Skip to content
Deluge Community
Based on the Deluge Manual – Amadeus Edition (draft). Being updated for community firmware up to C1.3.

2.1 Power Up

Charging / powering deluge

  1. Connect the USB cable to Deluge and ensure it is connected to a powered USB device or the 9-12V (centre negative) external supply is connected. The power / USB led will illuminate to indicate power status.

Powering up deluge

  1. Ensure the device is charged or connected to a USB or external PSU.
  2. Ensure the SD card is installed (pins / connectors facing up) using the SD card slot at the front of the unit.
  3. Turn the unit on by switching the ON/OFF switch located at the rear of the device to ON.
  4. Deluge will power up in ‘clip view’ with a blank song and one blank clip with an assigned synth preset ‘000 Rich Saw Bass’ as shown on the display.
  5. Although the sequence can be played, the clips and song are blank at this stage.
  6. The synth can be played manually using the right ‘audition / section’ pads where the notes are played chromatically (when SCALE is off) or by default C Major, 7-Note scale. The display will indicate the note as its played.