Skip to content
Deluge Community
Based on the Deluge Manual – Amadeus Edition (draft). Being updated for community firmware up to C1.3.

21.4 Deluge Pad Colours

Deluge has options to change the pad illumination including colours, brightness and refresh rate. A predefined refresh rate is set for optimal user comfort. However there may be a requirement to film deluge with various devices such as smart-phones, tablets, cameras, etc. The refresh rate may be set to match your device and allow a higher quality recording of Deluge.

Setting deluge user interface refresh rate

  1. Press & hold Clip + turn Turn SelectSelect.
  2. Adjust until the flickering as observed through the camera or device has gone or been reduced. Settings above 200 and below 8 are NOT recommended as this may affect visual performance.
  3. Settings are not saveable so this would need to be changed per filming session.

Setting deluge pad brightness

  1. Press & hold Shift + Learn/Input + turn Turn VerticalVertical.
  2. Adjust until the desired pad brightness.
  3. Settings are not saveable.
C1.1 Saved pad brightness. Unwritten: you can help by adding content.

See Preserve Pad Brightness Preference Through Power Cycle.

Setting deluge pad colours

  1. In Clip view.
  2. Press & hold Shift + turn Turn VerticalVertical.
  3. Adjust until the desired pad colours are set. Colours will be reflected in other views. This may be particularly useful in SESSION view.

Note: Default Mute / Launch pad rows colours for active, muted, stopped and soloed states can also be set in the pad menu within the settings options.